I want to ask if the best way to route the D/O of the WZ would be to:
A) Send the lightpipe directly to the DAW or
B) Send the lightpipe directly to the ADAT card
in the DA7 then D/I to the DAW? or
C) Send the audio via buss then D/I to the DAW?
I did a session last night and the vocalist was experiencing latency. The audio was delayed back to the vocalist because I have the DAW out back to the console. Should I just send the mic to the channel via ADAT card, then assign L/R(monitor mix) AND assign to the buss or D/O out to the DAW?
I want to use it for both recording situations.
Since I record no more than two sources at a time to the DAW, I would be wasting the other 6-7 outs and could use them to go to the DA7 for mixing.
Would there be delay when routing to the ADAT card then D/O to the DAW via the channel?
Is there another way to do this? I cannot use AES for anything except Mixing down or Mastering if I choose not to use another source converter.
By the way, IS ther and AES splitter box out there somewhere?
Thanks RaJ..............Out..............